Coaxiality and runout tolerances
 | |||||
| Shaft diameter | Total tolerance | ||||
| nominal | for coaxiality deviation | ||||
| and runout | |||||
| d1 | Kd1 | ||||
| over | incl. | over | incl. | max | |
| mm | in. | mm | in. | ||
| V-rings, VR1/VA and VR2/VS designs | |||||
| 9,5 | 0.374 | 0,4 | 0.016 | ||
| 9,5 | 19,5 | 0.374 | 0.768 | 0,6 | 0.024 |
| 19,5 | 38 | 0.768 | 1.496 | 0,9 | 0.034 |
| 38 | 68 | 1.496 | 2.677 | 1,1 | 0.043 |
| 68 | 105 | 2.677 | 4.134 | 1,4 | 0.055 |
| 105 | 155 | 4.134 | 6.102 | 1,6 | 0.063 |
| 155 | 210 | 6.102 | 8.628 | 1,9 | 0.075 |
| 210 | 2 020 | 8.628 | 79.527 | 3,6 | 0.142 |
| V-rings, VR3/VL designs | |||||
| 135 | 630 | 5.315 | 24.803 | 1,5 | 0.059 |
