Counterface tolerances for metric shafts
| Shaft | Diameter | ||
| diameter | tolerance (ISO h11)1) | ||
| Nominal | Deviation | ||
| d1 | |||
| over | incl. | high | low |
| mm | μm | ||
| 6 | 10 | 0 | -90 |
| 10 | 18 | 0 | -110 |
| 18 | 30 | 0 | -130 |
| 30 | 50 | 0 | -160 |
| 50 | 80 | 0 | -190 |
| 80 | 120 | 0 | -220 |
| 120 | 180 | 0 | -250 |
| 180 | 250 | 0 | -290 |
| 250 | 315 | 0 | -320 |
| 315 | 400 | 0 | -360 |
| 400 | 500 | 0 | -400 |
| 500 | 630 | 0 | -440 |
| 630 | 800 | 0 | -500 |
| 800 | 1 000 | 0 | -560 |
| 1 000 | 1 250 | 0 | -660 |
| 1 250 | 1 600 | 0 | -780 |
| 1 600 | 2 000 | 0 | -920 |
| 2 000 | 2 500 | 0 | -1 100 |
| 2 500 | 3 150 | 0 | -1 350 |
| 3 150 | 4 000 | 0 | -1 650 |
| 4 000 | 5 000 | 0 | -2 000 |
- 1) For shaft diameters of 3 150 mm and above, refer to DIN 7172.
